中科搅拌机的搅拌原理决定了在搅拌过程中混凝土大部分被堆积在两个搅拌轴之间，使得搅拌臂和叶片与底部衬板之间的磨损降低，只需纤细磨损，甚无磨损，双卧轴强制式搅拌机衬板只选用一般钢板或耐磨铸铁就可以了。比起其他搅拌机要使搅拌混凝土升到很高的方位，要运用高速的挑选速度，对搅拌叶片的磨损较大，要运用选用昂贵的格外钢材，修补本钱行进得到了出色的改进；其次强行式搅拌机的搅拌效率高，并且设备有静液压启动器，搅拌噪声较小，并且搅拌物料搅拌完成后直接处于卸料口，卸料时间短。是强行式搅拌机搅拌不只发生在径向方向上，也发生在轴线方向上，主搅拌区位于搅拌体的圆周方向，可充分利用搅拌空间，使得骨料、水泥和水在搅拌叶片圆周速度较低的情况下在短的时间内到达均匀的搅拌方式，取得好的搅拌效果。
The mixing principle of Zhongke mixer determines that most of the concrete is piled between two mixing shafts in the mixing process, which reduces the wear between the mixing arm and the blade and the bottom lining plate. It only requires fine wear, or even no wear. The lining plate of the forced mixer with double horizontal shafts only uses ordinary steel plate or wear-resistant cast iron. Compared with other mixers, they need to raise the mixing concrete to a very high position, use high-speed selection speed, wear the mixing blades greatly, use expensive extra steel, repair cost has been improved; secondly, the mixing efficiency of forced mixers is high, and the equipment has hydrostatic starter, mixing noise is small, and mixing materials are mixed After completion, it is directly at the discharge port, and the discharge time is short. The key point is that the forced mixer mixing not only occurs in the radial direction, but also in the axial direction. The main mixing area is located in the circumferential direction of the mixing body, which can make full use of the mixing space, so that the aggregate, cement and water can reach a uniform mixing mode in a short time under the condition of low peripheral speed of the mixing blade, and achieve good mixing effect.
The above is a detailed introduction to the mixer principle of China Science and Technology Corporation, which is provided by China Science and Technology Corporation. If you want to know more, please contact us https://www.cnzkjf.com Website.
