1. 确保中科聚峰混凝土搅拌车处于停止状态,因为如果搅拌车处于高速旋转状态,当发动机启动时,瞬时力将会非常大,这将损坏减速机。
1. Ensure that zhongkejufeng concrete mixer is in the stop state, because if the mixer is in the high-speed rotation state, when the engine starts, the instantaneous force will be very large, which will damage the reducer.
2. 确保水箱中有足够的水，并有可用的减水剂。由于种种原因，这材料太干了。
2. Make sure there is enough water in the water tank and available water reducing agent. For various reasons, the material is too dry.
3.自动上料混合机点火前，检查油、防冻液、润滑油和冷却水。如发现不足，应重新补上。
3. Check oil, antifreeze, lubricating oil and cooling water before ignition of automatic feeding mixer. If any deficiency is found, it shall be made up again.
4. 还要检查自动上料搅拌机的灯光，尤其是腰部的灯光，一定要照射在轮胎边缘，施工现场经常会乱堆放钢材等东西，而且轮胎一侧比较薄弱。
4. Check the light of the automatic feeding mixer, especially the light at the waist, which must be on the edge of the tire. Steel and other things are often stacked randomly on the construction site, and one side of the tire is relatively weak.
5. 还要用抹布清洁后视镜和两边的玻璃。施工现场情况复杂，光线不好。
5. Clean the rear-view mirror and the glass on both sides with a rag. The construction site is complex with poor light.
6. 汽车启动后，让汽车以低速旋转。检查一下车周围的胎压，看看有没有爆胎.
6. After the car starts, let the car rotate at a low speed. Check the tire pressure around the car to see if there is a flat tire
The above is the detailed introduction of the inspection that must not be forgotten before the concrete mixer truck of Zhongke Jufeng is started. For more information, please click the official website https://www.cnzkjf.com
