一、
搅拌车拖轮是干什么的？
1、 What is the tugboat of China Science mixer?
搅拌车拖轮是个轴承，用于把罐体支撑起来，与搅拌车是一体的，辅助搅拌。
The mixer tugboat is a bearing, which is used to support the tank and is integrated with the mixer to assist mixing.
2、 How to change oil for hydraulic pump of Zhongke mixer truck?
一般不建议自己换，直接到售后点找人员更换，而且使用的油必须符合要求，不然对设备损害很大，使用寿命也会大大缩短，更换合理标号的液压油。
Generally, it is not recommended to replace it by yourself, but go directly to the after-sales point for professional replacement. Moreover, the oil used must meet the requirements. Otherwise, the equipment will be greatly damaged and the service life will be greatly shortened. Replace the hydraulic oil with reasonable label.
三、搅拌车罐体填充率跟罐体倾角有什么关系？
3、 What is the relationship between tank filling rate and tank inclination angle?
目前搅拌车倾角在12度左右，填充率为63%左右，倾角不好测量，填充率也很难计算。目前销售的搅拌车都以有效搅拌容积为准。
At present, the inclination angle of the mixer truck is about 12 degrees, and the filling rate is about 63%. It is difficult to measure the inclination angle and calculate the filling rate. At present, all the mixers sold are based on the effective mixing volume.
四、混凝土搅拌车罐不转，转开了没力而液压油从邮箱加油口喷出来是什么原因？
4、 What is the reason why the tank of the concrete mixer doesn't rotate and the hydraulic oil sprays out from the oil port of the mailbox?
液压一个进一个回，进没力可能是油泵封闭部分坏了。回油冲，可能是油泵封闭脚垫坏了。
The hydraulic pressure enters and returns one by one. The inlet force may be due to the broken sealing part of the oil pump. Return oil flush, maybe the oil pump sealing foot pad is broken.
五、搅拌车搅拌筒的转速是多少？
5、 What is the rotational speed of mixer drum?
进料时搅拌筒的转速是：6---10转/分；搅拌时搅拌筒的转速：6--10转/分。
The rotating speed of the mixing drum during feeding is 6-10 rpm, and that of the mixing drum during mixing is 6-10 rpm.
六、8--12方的混凝土搅拌车进料口到地面距离是多少？
6、 What is the distance between the feeding port and the ground of 8-12 cubic meters concrete mixer truck?
一般8--12方的搅拌车整车高度大概在3.8米左右，进料口距离地面就有3.5米左右，具体的根据不同的车型来定。
Generally, the vehicle height of 8-12 cubic meters mixer is about 3.8 meters, and the distance between the feed inlet and the ground is about 3.5 meters, which is determined according to different models.
七、水泥搅拌车怎么清洗罐？
7、 How to clean the tank of cement mixer?
搅拌车配的水箱，每次卸完料后就应该将水放入罐内，在返回时搅拌行使，到搅拌站后再将水排出接料。罐体外表应该在水箱加水时即可顺便清洗。当然也可以直接用水箱内的水清洗。如果水泥浆已经凝固，罐体内找的清罐，外表凝固用草酸刷洗就行了。
The water tank equipped with the mixer truck should put the water into the tank after unloading each time. When returning to the mixing station, the water should be discharged to receive materials. The surface of the tank should be cleaned when the water tank is filled with water. Of course, it can also be directly cleaned with water in the water tank. If the cement slurry has solidified, find a professional cleaning tank inside the tank, and brush the surface with oxalic acid.
The above is about the concrete mixer truck common problems and treatment methods related content, I hope to help you, want to learn more content, welcome to click on the Zhongke mixer https://www.cnzkjf.com Official website.
