In order to avoid the good performance of the equipment in use, we need to carry out reasonable maintenance of the equipment. So what should be paid attention to in the process of equipment maintenance?

　　1、搅拌筒：在初次使用到50小时时，要及时检查罐体及其他部位螺栓是否有松动，每天行车前要检查托轮与滚道的润滑，每个月打开一次托轮护罩，清理内部的油污并添加润滑油脂。

　　1. Mixing drum: when it is used for 50 hours for the first time, check whether the bolts on the tank body and other parts are loose. Before driving every day, check the lubrication of the supporting roller and raceway. Open the cover of the supporting wheel once a month to clean up the internal oil stain and add lubricating grease.
               

　　2、液压驱动系统：液压系统是搅拌车的核心系统。为保证搅拌车能正常工作，搅拌罐能运转正常，必须在每次车辆发动前检查油路散热器和减速机的液压油位，保证油位指示在视窗范围内。同时要保证它的清洁，不能让灰尘等污染系统液压油，造成系统不能正常工作或损坏。

　　2. Hydraulic drive system: the hydraulic system is the core system of the mixer. In order to ensure the normal operation of the mixer and the normal operation of the mixing tank, the hydraulic oil level of the oil radiator and reducer must be checked before the vehicle starts to ensure that the oil level indication is within the window range. At the same time to ensure that it is clean, do not let dust and other pollution system hydraulic oil, resulting in the system can not work normally or damage.

　　3、供水系统：气压供水系统加水量尽量在水箱的四分之三处，经常检查阀体是否堵塞或是否有工作异常。在有结冰可能的环境中使用时，供水系统必须排空存水，防止管路冻裂。

　　3. Water supply system: the water quantity of air pressure water supply system should be 3 / 4 of the water tank as much as possible. Check whether the valve body is blocked or whether there is abnormal work. When it is used in the environment with the possibility of icing, the water supply system must be drained to prevent the pipeline from freezing and cracking.

　　除了上述这些知识内容外，经常性的检查中科自上料搅拌车系统的密封性，拆卸修理后，关键部位要涂螺纹密封胶车辆在行驶时水路系统中各个阀门均应处于关闭状态，以免影响车辆的制动性能，或烧结摩擦片，从而影响车辆的制动性能。

　　In addition to the above knowledge, we should regularly check the sealing of Zhongke self feeding mixer system. After disassembly and repair, the key parts should be coated with thread sealant. When the vehicle is running, all valves in the waterway system should be in the closed state, so as to avoid affecting the braking performance of the vehicle or sintering friction plate, thus affecting the braking performance of the vehicle.