中科自上料搅拌车这种机械设备在长时间的使用过程中,为了能够保持其良好的操作性能,则需要我们不定期的对其进行润滑工作。那么在对设备添加润滑油的过程中我们应该要注意哪些事项呢?
In order to maintain its good operation performance, we need to lubricate it irregularly during the long-term use of this mechanical equipment. So what should we pay attention to in the process of adding lubricating oil to the equipment?
1、中科自上料搅拌车在运转过程中不得检修和润滑。
1. Zhongke self feeding mixer shall not be repaired and lubricated during operation.
2、定期向各黄油嘴加注黄油,轴端密封处每4小时注润滑油一次,每周排污一次。
2. Fill grease to each grease fitting regularly, fill lubricating oil into the shaft end seal every 4 hours, and drain water once a week.
3、混凝土搅拌车在使用后酌情对各润滑点加注必要的润滑油(滚轮轴、滚轮、钢丝绳等活动部位)。
3. After the concrete mixer is used, the necessary lubricating oil (roller shaft, roller, wire rope and other moving parts) shall be added to each lubricating point as appropriate.
4、混凝土搅拌车减速箱的齿轮和轴承是利用齿轮回转将机油飞溅到箱体内壁,流入轴承中去进行润滑的。减速箱的油面应保持在油标尺两刻线之间为宜。油面过高或过低会导致各部温度升高或润滑不良,增加功率损耗和造成机器工作不良。
4. The gear and bearing of the concrete mixer gearbox use the gear rotation to splash the oil into the inner wall of the box and flow into the bearing for lubrication. The oil level of reducer should be kept between the two lines of oil scale. If the oil level is too high or too low, the temperature of each part will rise or the lubrication will be poor, the power loss will increase and the machine will work poorly.
5、中科自上料搅拌车选用的润滑油应具有一定购粘度和粘温特性,凝点低,抗氧化安定性良好,没有机械杂质和水分,不合腐蚀和磨损物质等。其质量指标应符合标准规定。
5. The lubricating oil selected by Zhongke self loading mixer truck should have certain viscosity and viscosity temperature characteristics, low freezing point, good oxidation resistance stability, no mechanical impurities and moisture, no corrosion and wear substances, etc. The quality index should conform to the national standard.
混凝土搅拌车进行润滑工作是为了能有效减少磨损,提高元部件的使用寿命。不过在进行添加润滑油的过程中也要注意一些事项,新机开始使用头150小时和300小时要分别更换机油一次,以便排除试车时未完全洗净的污物。工作时,要经常检查油面高度,不足应及时添补。
The lubrication of concrete mixer truck is to effectively reduce wear and improve the service life of components. However, in the process of adding lubricating oil, we should also pay attention to some matters. In the first 150 hours and 300 hours of use of the new machine, the engine oil should be changed once, so as to remove the dirt that is not completely cleaned during the test run. When working, the height of oil level should be checked frequently, and the shortage should be supplemented in time.
Thank you for reading, hope the above content is helpful to you, if you want to know more wonderful content, please click our official website: Zhongke self loading mixer https://www.cnzkjf.com .