There are problems in the self loading mixer sometimes, because a large number of dirt and slag in the self loading mixer are not cleaned up, so it needs to be cleaned in time to make it operate normally. Next, I'll teach you how to clean up dirt and slag.

　　1. 准备应急驱动软管，关闭自喂混合器，拆卸液压马达上的高压油管接头。

　　1. Prepare the emergency drive hose, close the self feeding mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.

　　2. 关闭救援车，取下其液压马达的高压油管，与应急驱动软管连接到故障车辆对应的接头上。

　　2. Close the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect the emergency drive hose to the corresponding connector of the failed vehicle.

　　3.启动救援车，将控制手柄推卸料位置，故障小车内的混凝土立即卸料。

　　3. Start the rescue vehicle, push the control handle to the unloading position, and the concrete in the fault vehicle will be unloaded immediately.

　　4. 紧急驱动后，拆卸驱动软管，恢复两辆车的原始状态。

　　4. After emergency drive, remove the drive hose and restore the original state of the two vehicles.

　　5,简单点的方法之间的楔形辊和种族,控制搅拌滚筒的转动,发动机熄火,挣脱高压油管,液压马达的混合桶可以自由旋转,控制搅拌滚筒的转动,使维修孔底部,然后打开维修孔,清理混凝土缸。混凝土排出后，使搅拌机恢复到原来的状态。

　　5. A simple way is to control the rotation of the mixing drum by wedge-shaped roller and race. The engine is turned off and the high-pressure oil pipe is pulled free. The mixing drum of the hydraulic motor can rotate freely. The rotation of the mixing drum is controlled to make the bottom of the maintenance hole, then the maintenance hole is opened and the concrete cylinder is cleaned. After the concrete is discharged, the mixer is restored to its original state.

　　以上是中科聚峰自上料搅拌车清洗土渣的方法，无论选择哪种方法，都要注意。毕竟，身体是革命的本钱。

　　The above is the method for Zhongke Jufeng self loading mixer to clean soil slag. No matter which method is selected, pay attention to safety. After all, the body is the capital of revolution.