1、 Introduction to running in period of Zhongke Jufeng concrete mixer中科聚峰混凝土搅拌车磨合期是指新车或大修后的初期驾驶阶段，一般为1000~1500，这是保证机器充分接触、摩擦、适应、定型的基本里程。在此期间,混凝土搅拌机的每一部分的能力适应环境可以调整和部分上的肿块可以搓掉。混凝土搅拌机的优点和缺点中运行会对人生有重要的影响,混凝土搅拌机的和经济。

　　The running in period of Zhongke Jufeng concrete mixer refers to the initial driving stage after new car or overhaul, generally 1000-1500 km, which is the basic mileage to ensure full contact, friction, adaptation and finalization of the machine. During this period, the ability of each part of the concrete mixer to adapt to the environment can be adjusted and the lumps on the part can be rubbed off. The advantages and disadvantages of concrete mixer in operation will have an important impact on life, the safety and economy of concrete mixer.

　　经过工厂的新混合器，虽然已经磨合完毕，但零件表面仍然粗糙。另外，在装配过程中存在一定的偏差，存在一些难以发现的隐患。另外，新零件和附件中，有很多金属颗粒脱落，这些金属颗粒不仅使零件之间的磨损，而且落入油液中会使油液的质量下降，影响润滑的效果。由于新零件在运行过程中产生的摩擦阻力比正常时期要大，所以耗油量也会更高。

　　After the new mixer in the factory, although it has been run in, the surface of the parts is still rough. In addition, there are some deviations and hidden dangers in the assembly process. In addition, in the new parts and accessories, a lot of metal particles fall off. These metal particles not only make the wear between parts, but also make the quality of the oil drop into the oil, which will affect the lubrication effect. Because the friction resistance of the new parts during operation is greater than that in normal period, the fuel consumption will also be higher.

　　1. 磨合过程:混凝土搅拌车的磨合距离为1000-2500，进口车的磨合周期较长，大部分为1500-3000。磨合期分为三个阶段。初始跑合距离可达100，初始跑合度可达200，氧化膜形成可达3000。

　　1. Running in process: the running in distance of concrete mixer truck is 1000-2500 km, and the running in period of imported truck is long, most of which is 1500-3000 km. The running in period is divided into three stages. The initial running in distance can reach 100 km, the initial running in degree can reach 200 km, and the formation of oxide film can reach 3000 km.

　　2. 行驶速度:试车期间尽量低速行驶。一般来说，卡车的速度不应超过45/小时，卡车的速度应在50-80/小时。此外，不要让引擎闲置太久之前，你开始。次驾驶后300内应避免紧急制动。

　　2. Driving speed: try to drive at low speed during the test run. Generally speaking, the maximum speed of the truck shall not exceed 45 km / h, and the maximum speed of the truck shall be 50-80 km / h. Also, don't let the engine idle too long before you start. Emergency braking shall be avoided within 300 km after the first driving.

　　以上是中科聚峰搅拌机厂家为大家介绍的相关内容，想要了解更多内容，欢迎访问网站：https://www.cnzkjf.comThe above is the relevant content introduced by Zhongke Jufeng blender manufacturer. To learn more, please visit the website: https://www.cnzkjf.com