自动上料混凝土中科搅拌车手工擦洗车身的主要材料是：清水，工具是水桶，软毛刷，毛巾，和干毛巾。
The main materials used in the auto feeding concrete mixer are: clear water, the tools are bucket, soft brush, towel, and dry towel.
1、用毛巾蘸上水，从车顶上向下慢慢把车身全部淋湿。
1. Dip the towel in the water and slowly wet the car body from the roof down.
2、用湿水巾从车顶开始进行擦试，把污垢擦净，逐步向车窗，护围从上往下擦试，把污垢擦净，擦拭的毛巾不应带有砂粒，否则会把涂膜表面和玻璃擦伤或擦出划痕，这是不允许的。
2. Use a wet water towel to wipe the dirt from the roof, and gradually wipe the dirt toward the window and the enclosure from the top to the bottom. The towel should not contain sand particles, otherwise the coating surface and glass will be scratched or scratched, which is not allowed.
3、对污物较多处，可先用柔软的毛刷刷洗，然后浇清水冲洗，再用毛巾擦洗。
3. For more dirt, you can first brush with a soft brush, then rinse with water, and finally scrub with towel.
4、把车身擦洗一遍后，认真检查是否还有残余的污物，如有，则尖应马上重新进行擦拭，直到擦净为止。
4. After scrubbing the car body, carefully check whether there is residual dirt. If so, the tip should be wiped again immediately until it is cleaned.
5、用清洁的干毛巾按上述的方式，再次擦试车身，直到擦拭干净为止，不得残留污物和水迹。
5. Wipe the car body again with a clean dry towel in the above way until it is wiped clean, and there is no residual dirt and water mark.
This article introduces the automatic feeding concrete mixer manual scrubbing method, hoping to bring you help. If you want to buy concrete mixer truck, welcome to Zhongke Jufeng https://www.cnzkjf.com , Zhongke mixer is a good choice for you.
